Everyone has heard of the wire drawing machine, because of its flexible operation and high practicability, it is deeply loved by everyone. Regular maintenance is very important in daily production. It can not only extend the service life of the machine, but also increase work efficiency. Let's take everyone to understand how to maintain the wire drawing machine!

The wire drawing machine equipment should be checked for safety every time before starting the machine, and then add lubricating oil in a regular and quantitative manner according to the requirements of the lubrication chart. The oil should be clean and free of precipitation. After starting the machine, clean the machine with compressed air that has been purified and filtered. Pay attention to the cleanliness of the inner surface of the conveyor belt and the upper surface of the workbench. There should be no foreign matter on the surface of the sand pad and belt, so as not to affect the sanding accuracy. Check the lubricating oil of each gearbox frequently. Replace the bearing, transmission chain and sprocket every six months and refill the lubricating grease every two weeks. Regularly blow and wipe the belt swing control assembly, photoelectric cell and photoelectric switch, so as not to make the belt swing insensitive.

Pay attention to check the operation status of the equipment in time. If there is a problem with the steel wire drawing machine, it must be dealt with in time. The temperature of the temperature zone should be appropriate every time the panel drawing machine is shut down to restarted, otherwise it will cause the machine to be strained or damaged. Check the compressed air filter regularly to remove the condensate in the filter. Check the pressure sink air filter and fill in enough lubricating oil. The lubricating oil in the motor bearing should be replaced and refilled regularly, and the electrical part should be regularly checked for normal operation. Regularly check whether the pulleys, knobs, and buttons are damaged. If there are any severely worn parts, they should be replaced in time, and the spare parts should be reported for supplement.

Check the tension and wear of the narrow V-belt, the tension of the conveyor belt of the machine tool, the wear of the pneumatic brake pads, and the flatness of the worktable. During operation, if the machine is found to be abnormal, it should be shut down in time and restarted after troubleshooting. To provide a good working environment and working condition for the equipment, regular cleaning work should be carried out to keep the machine tools of the steel wire drawing machine clean and hygienic, and appropriate anti-rust measures should be taken for the unpainted parts. Regularly check and repair the switches and wire drawing dies for wear. Remember to add lubrication regularly and quantitatively according to the requirements of the lubrication chart before starting the machine.

The above is the maintenance of the wire drawing machine. Regular maintenance can not only extend the service life of the machine, but also reduce the hidden dangers of machine accidents, increase work efficiency, and reduce maintenance costs. I hope that the above content can help everyone, if If you need products, you can contact us, welcome to inquire!