We are familiar with the drawing machine, the production of many products in our life can often be used, so the use of wire drawing machine have what operating procedures, let's take a look at it!

The operator should hold the drawing machine operation qualification certificate, it is forbidden to operate the machine without the certificate, to carry out productive processing operation in fixed equipment, it is forbidden to operate the machine or series operation by non-machine personnel. Operators should be loyal to their duties, serious and responsible, master the operation, maintenance and maintenance of the equipment, and constantly summarize and learn to improve their own quality, familiar with the basic operating parameters and performance indicators of the equipment. Before operation, the operator should wear gloves to prevent the workpiece from burning fingers and affecting product quality. The machine tool electrical equipment should be well grounded, and the limit screws of the two stroke bump blocks should be complete.

Lubrication of each lubrication point, not less than 1 time per shift, and often check the lubrication of each transmission part. Before starting the machine, carefully check the air supply of the equipment, whether the air supply pipeline leaks, and discharge the water in the air filter. The wire drawing machine and dust collecting fan can not be started at the same time, the operator can not leave the work post after starting. When two people are working, the operator behind the equipment shall not be facing the exit of the drawing machine, so as to avoid the workpiece flying out of harm. The pressure adjustment of the wire drawing machine should be moderate. It is strictly prohibited to cross the red line, so as not to cause equipment or personal accidents. Carefully check the upper and lower bearing seat and lifting screw lubrication is good, ensure that no person on the front of the discharge before starting. If the equipment is abnormal during operation, it should be shut down or cut off in time to avoid further failure.

After the equipment is started, it shall timely check whether the sand belt swing is within the required range and whether there are other abnormal phenomena. Otherwise, it shall timely adjust or shut down. Before processing, drawings and operation data should be carefully read to avoid batch scrap or waste. Finished workpiece should be handled gently, and layered protective packaging, so as not to cause damage to the workpiece surface. According to the operation requirements, carefully determine the drawing direction, drawing surface, the correct selection of drawing sand belt. The workpiece should be cleaned and then brushed, and the recycling bin should be cleaned in time to make the fan work normally.

The above is the operation of the wire drawing machine rules, in strict accordance with the rules of operation can not only reduce the accident hidden danger, but also prolong the service life of the machine, reduce the maintenance cost of the machine, I hope the above content can help you!