Everyone is familiar with the wire drawing machine, and many of the products produced are often used in our lives. So what are the operating procedures when using the wire drawing machine, let's take a look at it together!

Operators must hold a qualification certificate for drawing machine operation, and it is strictly forbidden for unlicensed personnel to operate on the machine, and for productive processing operations on fixed equipment, and it is strictly forbidden to operate on the machine or serial operation by non-machine personnel. Operators must be loyal to their duties, conscientious and responsible, proficient in the operation, maintenance and maintenance of this equipment, continue to summarize and learn, seek continuous improvement of their own quality, and be familiar with the basic operating parameters and performance indicators of the equipment. Before operation, the operator wears gloves to work to prevent the workpiece from burning fingers and affecting product quality. The electrical equipment of the machine tool must be well grounded, and the two limit screws of the stroke striker must be complete.

Lubricate each lubrication point at least once per shift, and check the lubrication of each transmission part frequently. Before starting the machine, check the air supply of the equipment carefully, whether the air supply pipeline is leaking, and drain the water in the air filter. The wire drawing machine and the dust collecting fan cannot be started at the same time, and the operator cannot leave the work post after starting. When working with two people, the operator behind the equipment must not face the exit of the wire drawing machine, so as to prevent the workpiece from flying out and hurting people. The pressure adjustment of the wire drawing machine should be moderate, and it is strictly forbidden to cross the red line to avoid equipment or personal accidents. Carefully check whether the upper and lower bearing seats and the lifting screw are well lubricated, and make sure that there is no one on the front of the discharge before starting the machine. If abnormal phenomena occur during the operation of the equipment, it should be shut down or cut off in time to avoid the expansion of the fault.

After the equipment is started, check whether the belt swing is within the required range and whether there are other abnormal phenomena. Otherwise, it should be adjusted or shut down in time. Read the drawings and operating materials carefully before processing operations to avoid batch scrap or waste. The finished workpiece should be handled with care, and layered protective packaging should be carried out to avoid injury to the surface of the workpiece. It is necessary to carefully determine the drawing direction and drawing surface according to the operating requirements, and correctly select the drawing abrasive belt. The workpiece must be cleaned and then drawn, and the recycling waste box must be cleaned in time to make the fan work normally.

The above are the rules for the operation of the wire drawing machine. Strictly following the rules can not only reduce the hidden dangers of accidents, but also extend the service life of the machine and reduce the maintenance cost of the machine. I hope the above content can be helpful to everyone!