Equipment operation is a link that cannot be ignored in the production of enterprises, and the Drawing Machine should also strictly follow the specifications during the operation process:

Operators must wear gloves to work to prevent the workpiece from burning fingers and affecting product quality. Read the drawings and technical data carefully before processing operations to avoid batch scrap or waste. When processing, you should carefully determine the drawing direction and drawing surface according to the technical requirements, and correctly choose the drawing abrasive belt. Wear gloves during the entire processing operation. Pay attention to the surface protection of the workpiece to prevent scratches and damage to the surface of the workpiece and cause waste. It is strictly forbidden to draw wire directly without cleaning the workpiece.

After the wire drawing machine is running normally, it is not allowed to stay near the wire drawing barrel for a long time. If you want to check the materials, you must shut down first. Install the wire drawing abrasive belt correctly (the direction of the arrow on the inner side of the wire drawing abrasive belt should be the same as the arrow on the drawing roller). Carefully check whether the upper and lower bearing seats and the lifting screw are well lubricated, and make sure that there is no one on the front of the discharge before starting the machine. After the equipment is started, immediately check whether the belt swing is within the required range and whether there are other abnormal phenomena, otherwise, it should be adjusted or shut down immediately. In the process of drawing, pay attention to the straightness and smoothness of the plate element on the plate element rack. It is strictly forbidden to draw wire directly without cleaning the workpiece. The finished workpiece should be handled with care, and layered protective packaging should be carried out to avoid injury to the surface of the workpiece. Clean the recycling waste box in time to ensure the normal operation of the fan.

Start the upper die normally, and the speed is slower when starting up, and then gradually increase, so as to be able to reach the working state. Unload the material, make a record, and attach a label. The material head and the unloading rack must be stable to avoid damage to the equipment. If the equipment is abnormal during operation, it should be shut down and power off immediately to avoid the expansion of the fault. When the equipment is overhauled, the main power supply should be turned off, and the operation should be strictly prohibited with a sign to avoid accidents. Turn off the main power supply and compressed air when the equipment is off work or when the equipment is in use for a long time to ensure that the equipment is turned off.

The above is the basic operation process of the wire drawing machine that we have summarized for everyone, and hope to help you.